Summary

Adds a solids4foam solid participant to turek-hron-fsi3, adapted from the HronTurekFsi3 benchmark that solids4foam ships. This is a natural fit: solids4foam maintains its own version of this benchmark, so the tutorial gains a cross-check against the deal.II and Nutils participants.

• Neo-Hookean, nonlinear-geometry total-Lagrangian solid model, PETSc SNES, alpha stabilisation.
• Material properties match the deal.II case: E = 5.6 MPa, nu = 0.4, rho = 1000 kg/m³.
• 630-cell beam (105 x 6), patches renamed to interface / fixed / frontAndBack to match the repo's conventions.
• The interface patch uses the solids4foam solidTraction boundary condition, whose tractionField option consumes the solidTraction volVectorField that the adapter fills.

Results

Full 15 s run (15000 time windows), fluid on 20 MPI ranks, solid serial. Flap-tip y-displacement over the settled limit cycle (t = 8 to 15 s), against the Turek-Hron FSI3 benchmark value of uy = 1.48 +/- 34.38 mm:

Choice of polynomial order

Since the high-order (polynomial reconstruction) discretisation is a cost/accuracy knob, I ran the full 15 s simulation three times, changing only polynomialOrder and holding everything else fixed:

Accuracy improves monotonically with order. The solid solver is genuinely 3.2x more expensive at p=3 (solid CPU time 5023 s -> 15913 s), but the end-to-end runtime is essentially unchanged, because in this tutorial the fluid participant dominates and the extra solid work hides behind the coupling. Wall-clock times were 28594 s, 27315 s and 29345 s respectively — within the noise of other jobs sharing the node.

I therefore propose polynomialOrder 3, but the trade-off is documented in the README and switching is a one-line edit, so please say if you would rather ship a cheaper solid. Note that polynomialOrder 2 is both cheaper and more accurate than no high-order reconstruction at all, so the plain low-order option is dominated.

One observation independent of the solid settings: all three variants give an oscillation frequency of 5.50-5.64 Hz against the benchmark's 5.3 Hz. Since polynomial order does not move it, that offset comes from the fluid side or the coupling rather than the solid discretisation.

Tested with OpenFOAM v2606, preCICE 3.4.1, solids4foam (development) and the OpenFOAM adapter from precice/openfoam-adapter#417.

Notes

• Requires solids4foam v2.4 or later built with PETSc, and an OpenFOAM-preCICE adapter with support for reading Stress in solid participants.
• The reference-results tarball still needs to be generated; the tests/tests.yaml entry already points at the expected path.
• This PR and Add a solids4foam solid participant to elastic-tube-3d #914 / the multiple-perpendicular-flaps PR each add an entry to the solids4foam test suite in tests/tests.yaml, so whichever merges last will need a trivial rebase there.

🤖 Generated with Claude Code

https://claude.ai/code/session_01SBFTMffUN7qDigrDQrPVb2